Sony SLV-EZ77AS - Manual (Page 11)

11 Getting Started
Getting Started
Step 4
Tuning your TV to the VCR
If you have connected your VCR to the TV using the audio/video cable, skip
this step.
1
Press 1/u ON/STANDBY to turn on the VCR.
2
Press RF CHANNEL on the VCR.
The factory-preset RF channel flashes in the display window for
about three seconds (RF32 for SLV-EZ77NZ, RF36 for SLV-EZ77AS
and 36 AUS for SLV-EZ66AZ).
Press RF CHANNEL again while the RF channel is flashing.
The VCR signal is output through this channel to the TV.
3
(For SLV-EZ66AZ only)
Press PROGRAM +/– to select the suitable RF channel, depending
on the area you live in.
You can select Australia channels from 28 AUS to 69 AUS or New
Zealand channels from 28 NZ to 69 NZ.
The Australia and New Zealand channels appear in the display
window in alternate sequence.
4
Turn on your TV and select a programme position for the VCR
picture.
This channel will now be referred to as the video channel.
Some TV has the programme position, such as 0, that is reserved for
a VCR. In this case, select that programme position for the VCR
picture. Refer to the instruction manual of your TV for details.
RF CHANNEL
1/u ON/STANDBY
continued
PROGRAM +/–
ON/STANDBY
RF CHANNEL
SP
APC
PROGRAM
+ –