Connecting an s-vhs vcr – Samsung Tantus PCK 6115R User Manual

Page 19

Advertising
background image

C

HAPTER

T

WO

: I

NSTALLATION

2.5

le

g.

u-

I

N S TA L L AT I O N

3

Connect a coaxial cable
between the ANTENNA
OUT terminal on the
VCR and the antenna
terminal on the TV.

4

Connect a set of audio
cables between the
AUDIO OUT jacks on the
VCR and the AUDIO
jacks on the TV.

5

Connect a video cable
between the VIDEO OUT
jack on the VCR and the
VIDEO jack on the TV.

Follow the instructions in “Viewing a VCR or Camcorder Tape” to view your VCR tape.

A coaxial cable is usually included with a VCR. (If not, check your local electronics
store).

If you have a “mono” (non-stereo) VCR, use the Y-connector (supplied) to hook up to
the left and right audio input jacks of the TV. If your VCR is stereo, you must connect
two cables.

1

To begin, follow steps
1–3 in the previous
section to connect the
antenna or cable to your
VCR and your TV.

Connecting an S-VHS VCR

Your Samsung TV can be connected to an S-Video signal from an S-VHS VCR. (This
connection delivers a better picture as compared to a standard VHS VCR.)

Make sure the jacks you are using are underneath the number “2.”

2

Connect a set of audio
cables between the
AUDIO OUT jacks on the
VCR and the 2 AUDIO
INPUT jacks on the TV.

00583F(E)-CHAPTER 2 7/19/05 2:30 PM Page 5

Advertising
This manual is related to the following products: