Sharp TINSEB520MRK0 - Manual (Page 3)

CustOMer assistanCe
To assist in reporting this appliance, please record below the model number and serial number located on the unit. We also
suggest you record all the information listed and retain for future reference.
MODEL NUMBER SERIAL NUMBER
DATE OF PURCHASE / /
DEALER TELEPHONE
SERvICER TELEPHONE
tO pHOne:
DIAL 1-800-BE-SHARP (237-4277) for:
SERVICE (for your nearest Sharp Authorized Servicer)
PARTS (for your authorized parts distributor)
ADDITIONAL CUSTOMER INFORMATION
tO Write:
Sharp Electronics Corporation
Customer Assistance Center
1300 Naperville Drive
Romeoville, IL 60446-1091
Please provide the following information when you write or call: model number, serial number, date of purchase, your complete
mailing address (including zip code), your daytime telephone number (including area code), your email address and description
of the problem.
tO aCCess internet: www . sharpusa.com
3
ELECTRICAL REqUIREMENTS
A 120V, single phase, 60 Hz, AC only 15 or 20 amp electrical supply,
properly grounded in accordance with the National Electric code and
local codes and ordinances is required.
imPortant The appliance is equipped with a three-prong
grounding plug for protection against possible electric shock hazards.
It must be plugged into a dedicated, grounded, electrical outlet. If only
a two-prong electrical outlet is available, it is the responsibility of
the customer to have it replaced with a dedicated, properly grounded
three-prong electrical outlet. Do not under any circumstances:
Cut or remove the third (ground) prong from the powercord. •
Use a power cord that is frayed or damaged. •
Connect the appliance to an extension cord. •
Do not use an adaptor to fit plug to outlet. •
Note: Use of a ground fault interrupter (GFI) is not recommended.
* serial number is located on name plate
name plate
location