Sony SRX-T110 - Manual (Page 31)

31
INSTALLATION Window
Cha
p
te
r 4
A
d
jus
tment
s
a
nd Se
tt
ing
s
Us
ing t
he SRX
Con
tr
o
ller
SIRCS
Sets to enable or disable operations using the remote
commander.
To enable operations, press the “On” radio button. To
disable operations, press the “Off” radio button.
IMAGE FLIP
Flips the picture.
Select it from the drop-down list displayed by clicking
according to the installed condition of the projector.
Off: Normal projection
H: Flips the picture horizontally
V: Flips the picture vertically
HV: Flips the picture horizontally and vertically
PROGRESSIVE DISPLAY MODE
Normally, click the “Off” radio button.
Click the “On” radio button when the signals from four
input boards are used to project a 2048 (1920) × 1080
pixels signal as a 4096 (3840) × 2160 pixels 4K image or
to project a 1400 × 1050 pixels (SXGA+) signal as a 2800
× 2100 pixels image in single-screen mode.
SQUEEZE
This function allows the input signal to be displayed on the
screen in a converted aspect ratio.
When you click the “On” radio button, the following input
signals can be displayed on the screen by horizontal
stretching.
• Video 50 Hz or Video 59.94 Hz signal with a 4:3 aspect
ratio: Stretched to a 16:9 aspect ratio.
• 720p, 1920 × 1080 or 2048 × 1080 signal with a 16:9
aspect ratio: Stretched to a 2.39:1 aspect ratio.
When you click the “Off” radio button, the input signal is
displayed without converting the aspect ratio.
This function is available only for projection in single-
screen mode.
LAMP POWER
Adjusts the lamp power output.
Select it from the drop-down list displayed by clicking
.
You can reduce the lamp power to 93%, 86%, 79%, 72%,
65%, 58% or 51%. Selecting “100%” allows you to obtain
the brightest projection image.
Switching the lamp output frequently may reduce the lamp
life. Use of the defined lamp output is recommended.
LAMP SELECT
Selects whether to use one of two lamps or both lamps.
Dual: Select when using two lamps.
Single: Select when using only one of two lamps.
In Single, you can further select the lamp to be used
automatically or manually.
Auto Lamp Select Mode
When you click the “Full Auto Select” radio button,
the lamp with fewer used hours is automatically
turned on. When you use the projector for a long
period of time, click the “User-Defined” radio button.
If you specify the hour between 4 and 24 hours by
clicking the
/ buttons, the two lamps turn on
alternately at the interval of the specified hours.
Manual Lamp Select Mode
You can specify the lamp to be used by clicking the
“Lamp A” or “Lamp B” radio button.
If you switch “LAMP SELECT” from “Single” to “Dual”
or when either Lamp A or Lamp B switches to turn on, the
projected image will be cut off momentarily (up to 10
seconds).
Off H
V HV
Note
Note
Note