Sony SRX-T110 - Manual (Page 38)

38
Specifications
Chapt
er 5 Ot
her
s
Specifications
Optical characteristics
Projection system
SXRD (Silicon X-tal Reflective Display)
3 panel prism color integration system
SXRD 8,847,360 pixels (4096 Ч 2160 Ч 3)
Lens Optional
Light output SRX-T110: 11,000 lm ± 20% (factory
preset value)
SRX-T105: 5,500 lm ± 20% (factory
preset value)
Lamp SRX-T110: 2 kW Xenon lamp (2) (not
supplied)
SRX-T105: 1 kW Xenon lamp (2) (not
supplied)
Electrical characteristics
Acceptable signal
XGA, Quad-VGA, SXGA, SXGA+,
UXGA, WUXGA, HD, 2048 × 1080
(pre-installed board (LKRI-005) or
when the LKRI-004 or LKRI-005 is
installed)
Component, XGA, SXGA, UXGA, HD
(when the LKRI-001 analog input
board is installed)
HD-SDI (SMPTE Serial Digital Interface
standard) (when the LKRI-002 HD-
SDI (4:2:2) input board is installed)
HD-SDI (SMPTE Serial Digital Interface
standard) (when the LKRI-003 HD-
SDI (4:4:4) input board is installed)
Input/Output
DVI-D DVI connector, 24-pin (male) (For
details, see “Pin assignment” on page
39.)
AUX DVI connector, 24-pin (male) (For
details, see “Pin assignment” on page
39.)
INTER LOCK Minijack
Normal operation at short circuit
Lamp power off at open circuit
RS232C D-sub 9-pin (female) (For details, see
“Pin assignment” on page 39.)
ETHERNET 10BASE-T/100BASE-TX
Input signal
Pre-installed board (LKRI-005)
XGA, Quad-VGA, SXGA, SXGA+,
UXGA, WUXGA, HD, 2048 × 1080
When the LKRI-001 is installed
Analog RGB/component: BNC type
R/R-Y: 0.7 Vp-p ±2 dB positive, 75
ohms terminated
G/G SYNC: 0.7 Vp-p ±2 dB positive,
75 ohms terminated
G with sync/Y: 1 Vp-p ±2 dB sync
negative, 75 ohms terminated
B/B-Y: 0.7 Vp-p ±2 dB positive, 75
ohms terminated
SYNC/HD: Composite sync: 0.6 to 8
Vp-p, high impedance, sync positive/
negative
Horizontal sync: 0.6 to 8 Vp-p, high
impedance, sync positive/negative
VD: Vertical sync: 0.6 to 8 Vp-p, high
impedance, sync positive/negative
HDTV (YP
b
P
r
): BNC type
Y: 1 Vp-p ± 2 dB positive, 75 ohms
terminated
Tri-level sync: ± 0.3 Vp-p
Bi-level sync: 0.3 Vp-p
P
b /P r : 0.35 Vp-p ± 2 dB positive, 75
ohms terminated
HDTV (GBR): BNC type
G with sync: 1 Vp-p ± 2 dB, 75 ohms
terminated
Tri-level sync: ± 0.3 Vp-p
Bi-level sync: 0.3 Vp-p
B/R (GBR): 0.7 Vp-p ± 2 dB positive,
75 ohms terminated
When the LKRI-002 is installed
SMPTE format HD
When the LKRI-003 is installed
SMPTE Format HD-SDI/DC-SDI/Dual-
link HD-SDI/Dual-link DC-SDI
When the LKRI-004 or LKRI-005 is installed
XGA, Quad-VGA, SXGA, SXGA+,
UXGA, WUXGA, HD, 2048 × 1080
General
Dimensions 740 Ч 498 Ч 1326 mm (29
1
/ 4 Ч 19
5
/ 8 Ч
52
1
/
4
inches) (w/h/d)
Mass Approx. 120 kg (265 lb) (excluding the
optional lamps and lens)
Power requirements
SRX-T110: 200 to 240 V AC, 50/60 Hz
SRX-T105: 100 to 240 V AC, 50/60 Hz
Power consumption
SRX-T110: Max. approx. 5.4 kW
(Standby mode: 40 W)
SRX-T105: Max. approx. 3.0 kW
(Standby mode: 40 W)
Current consumption
SRX-T110: 30 to 22 A
SRX-T105: 30 to 12.5 A
Operating temperature