Samsung SilverCare WF306BAW - Manual (Page 20)

E-1 SAMSUNG Clothes Washer Owner’s Instructions
CHECK THESE POINTS IF YOUR WASHER...
will not start.. • Make sure door is firmly closed.
• Make sure your Washer is plugged in.
• Make sure the water source faucets are turned on.
• Make sure to press the Cycle Selector dial to start your Washer.
• Make sure the Child Lock is not activated; see page C4.
• Before your Washer starts to fill, it will make a series of clicking noises
to check the door lock and do a quick drain.
has no water or not
enough water..
• Turn both faucets on fully.
• Make sure the door is tightly closed.
• Make sure your Washer is plugged in.
• Check fuse or reset circuit breaker.
• Press the Cycle Selector dial to start your Washer.
• Straighten water inlet hoses.
• Disconnect hoses and clean screens. Hose filter screens may be
plugged.
• Open and close the door, then press the Cycle Selector dial.
has detergent remains
in the automatic
dispenser after the
wash cycle is complete.
• Make sure your Washer is running with sufficient water pressure.
• Make sure the Detergent Selector dial is in the upper position when
using granular detergent.
vibrates or is too noisy. • Make sure your Washer is set on a level surface. If the surface is not
level, adjust your Washer feet to level the appliance.
• Make sure that the shipping bolts are removed.
• Make sure your Washer is not touching any other object.
• Make sure the laundry load is balanced.
stops • Plug cord into live electrical outlet.
• Check fuse or reset circuit breaker.
• Close door and press the Cycle Selector dial to start your Washer. For
your safety, your Washer will not tumble or spin unless the door is
closed.
• Before your Washer starts to fill, it will make a series of clicking noises
to check the door lock and do a quick drain.
• There may be a pause or soak period in the cycle. Wait briefly and it
may start.
• Check screens on inlet hoses at the faucets for obstructions. Clean
screens periodically.
Troubleshooting