Samsung HC-P5256W - Manual (Page 11)

English - 11
Y O U R N E W T V
Connection Jacks (Rear)
Use the rear panel jacks to connect an A/V component that will be connected
continuously, such as a VCR or a DVD player. For more information on connecting
equipment, see pages 18~22.
ΠANTENNA terminals
Two independent cables or antennas can be
connected to these terminals. Use “Cable IN”
and “Air IN” terminals to receive a signal from
VHF/UHF antennas or your cable system. Use
the “Cable OUT” terminal to send the signal
being received by the “Cable IN” terminal out to
another component (such as a Cable Set-Top
Box). The PIP channel can be received only
when a signal source is connected to “Cable
IN”.
´ CableCARD Slot
Insert the CableCARD into the slot.
ˇ DVI Video Input jack
(Digital Visual Interface)
Connect the DVI jack to a device with DVI
output.
¨ Anynet
Please refer to the Anynet Owner’s Instructions.
ˆ OPTICAL Output jack
Connect to a Digital Audio component.
Ø COAXIAL Output jack
Connect to a Digital Audio component.
∏ Audio/Video Output jacks
Connect to the audio/video input jacks of a
recording VCR.
” Video Input jacks
Connect to the video output jacks of VCRs, DVD
players and similar devices.
’ Audio Input jacks
Connect to the audio output jacks of VCRs, DVD
players and similar devices.
˝ DVI Audio Input jacks
Connect to the audio output jacks of a device
with DVI.
Ô S-Video Input jack
Connect to S-VIDEO output jacks of an S-VHS
VCR or DVD player.
 COMPONENT Input jacks
(Y, P B , P R , AUDIO-L/R)
Connect to the Component audio and video
outputs of DVD or DTV Set-Top Box.
480i/480p/720p/1080i Y,P
B and P R video signal
inputs are available.
BP68-00334A-00Eng 5/20/04 4:52 PM Page 11