Soundstream Technologies X3.71 - Manual (Page 13)

Controls & Functions
12.B-Terminal (Chassis ground)
13. Remote Power On
To avoid unwanted ignition noise caused by ground loops, it is essential that the
Amplifier be grounded to a clean, bare, metal surface of the vehicles chassis.
Note : GROUND WIRE SHOULD NOT BE EXTENDED MORE THAN 3 FT (1 METER).
To remote wire From car stereo.
The amplifier is turned "ON" remotely when vehicle's stereo is turned "ON"
Note : IF YOUR RADIO DOES NOT HAVE +12 VOLT OUTPUT LEAD WHEN TURNED ON, THE
"REMOTE" TERMINAL ON THE AMPLIFIER CAN BE CONNECTED TO VEHICLES ACCESSORY
CIRCUIT WHICH PROVIDES +12V WHEN THE CAR IS ON.
14. Speaker Terminals
CONTR
OLS & FUNCTIONS
X3.60D
11
X3.71
X3.60D
X3.71
X3.60D X3.71