Sony KDS-70R2000 - Manual (Page 45)

45 GB
Usi
ng Op
ti
onal
Eq
uip
m
e
n
t
Programming the
remote
This remote is preset to operate Sony TVs, most Sony
DVDs, VCRs and AMPs (Home Theatre, etc.).
To control VCRs and DVDs of other manufacturers
(and some other Sony VCR, DVD and AMP models),
do the following procedure to programme the remote.
Note
Before you start, look up the three-digit code for your brand
of DVD, VCR or AMP from the “Manufacturer’s codes” on
page 46.
1
Press and hold the DVD, VCR or AMP
function button you want to programme on
the remote, then press
, keeping the
function button pressed down.
The selected function button (DVD, VCR or
AMP) will flash.
2
Press the number buttons to enter the
three-digit manufacturer’s code number
while the button is lit. If code is not entered
within 10 seconds, you must perform the
step 1 again.
3
Press .
When the programming is correct, the selected
function button will flash twice, and when not, it
will flash five times.
Digital audio
(PCM) component
K Connect to the DIGITAL OUT
(OPTICAL) socket using the
Optical audio cable.
Note
The DIGITAL OUT (OPTICAL)
socket only supports digital terrestrial
signals.
Hi-Fi audio
equipment L Connect to the audio output
sockets
to listen to the sound
from the TV on Hi-Fi audio
equipment.
To connect Do this
2
3
1
1
Continued