Sony RDR-GX33 - Manual (Page 25)

25
H
ook
up
s and
Se
tti
n
gs
b Notes
• Pictures containing copy protection signals that prohibit any copying cannot be recorded.
• If you pass the recorder signals through a VCR, you may not receive a clear image on your TV screen.
Be sure to connect your VCR to the DVD recorder and to your TV in the order shown below. To watch
video tapes, watch the tapes through a second line input on your TV.
• If you disconnect the recorder’s AC power cord, you will not be able to view the signals from the
connected VCR.
Connect a VCR or similar recording device to the LINE 2 IN jacks of this recorder. If the
equipment has an S-video jack, you can use an S-video cord instead of an audio/video cord.
z Hint
When the connected equipment outputs only monaural sound, connect to just the L(MONO) and VIDEO
input jacks on the front of the recorder. Do not connect the R input jack.
b Notes
• Do not connect the yellow LINE IN (VIDEO) jack when using an S-video cord.
• Do not connect the output jack of this recorder to another equipment’s input jack with the other
equipment’s output jack connected to the input jack of this recorder. This may cause noise (feedback).
• Do not connect more than one type of video cord between the recorder and your TV at the same time.
Connecting to the LINE 2 IN jacks on the front panel
VCR DVD recorder TV
Line input 1
Line input 2
DVD recorder VCR TV
OUTPUT
S VIDEO AUDIO
L R
VIDEO
VCR, etc.
Audio/video cord
(not supplied) S-video cord
(not supplied)
to LINE 2 IN
DVD recorder
: Signal flow