Smeg PGF75BE-2 - Manual (Page 8)

Instructions for the installer
26
2.3 Electrical connection
Make sure that the voltage and capacity of the power supply cable conform
to the data shown on the plate located under the protective cover. Do not
remove this plate for any reason.
The power supply cable plug and the wall socket must be of the same type
and conform to the current electrical system regulations. Check that the
power line is adequately earthed.
On the power line, install an all-pole disconnect switch with minimum contact
gap of 3 mm located at an easily accessible position near the appliance.
Do not use reducers, adapters or shunts.
If the power cable is to be replaced,
the wire section on the new cable must
not be less than 0.75 mm
2 (3 x 0.75
cable), bearing in mind that the end
tobe connected to the appliance must
have the earth wire (yellow-green) at
least 20 mm longer.
Use only H05V2V2-F cable or similar which has a maximum temperature of
90°C. Any replacement needed should be carried out by a specialised
technician who should make the mains connections according to the
following diagram.
L = brown
N = blue
= yellow-green
The manufacturer declines all liability for injury to persons or animals
and for damage to property resulting from non-observance of the above
prescriptions or from tampering with any part of the appliance.