Sennheiser EM 2000 - Manual (Page 28)

Adjusting settings via the operating menu
26
Displaying the software revision
You can display the current software revision of the receiver.
̈
For information on software updates, visit the corresponding product page on our website
at www.sennheiser.com.
The “ Sync-Settings ” submenu
“SK Settings”, “SKM Settings” and “SKP Settings”
Via the “ SK Settings ”, “ SKM Settings ” and “ SKP Settings ” submenus, you can set the trans-
mitter parameters directly on the receiver and activate or deactivate the transfer of these
parameters to the transmitter:
By pressing the button
¿ , you can transfer the parameters to the transmitters
(see page 14).
Tune
Guitar Tuner
Sync Settings
Pilot Tone
Warnings
LCD Contrast
Reset
IP-Address
Software Revision
Exit
Advanced Menu
Display Function
SK Settings Calls up the “ SK Settings ” submenu
SKM Settings Calls up the “ SKM Settings ” submenu
SKP Settings Calls up the “ SKP Settings ” submenu
Exit Exits the “ Sync Settings ” submenu and returns to the extended menu
“ Advanced Menu ”
SK Settings
SKM Settings
SKP Settings
Exit
Sync Settings
Setting Transfer is ...
... activated
... deactivated
Display Function Settings
Sensitivity Adjusts the input sensitivity:
SK –60 dB to 0 dB,
adjustable in steps of 3 dB
SKM and SKP –48 dB to 0 dB,
adjustable in steps of 6 dB
Low Cut (SKM only) Low cut filter can be activated/deactivated
Auto Lock Lock mode Inactive, Active
Mute Mode (SK, SKP only) Mute mode Disabled, RF On/Off, AF On/Off
RF Power Transmission power Low, Standard, High
Sensitivity
-60 dB
Sync
PEAK
-10
0 40
30
20
10
-20
-30
-40
AF RF
Sensitivity
-60 dB
Sync
PEAK
-10
0 40
30
20
10
-20
-30
-40
AF RF