Using the g-code feature ★(dvd-v80/ dvd-v85 only), Using the g-code feature, Dvd-v80/ dvd-v85 only) – Samsung V70 User Manual
Page 35
35
GB
Using the G-CODE Feature
★
(DVD-V80/ DVD-V85 Only)
Timer Method
If you want to set
the timer program,
press the key.
G-Code
Code
Code : 0 - 9
Correct :
Standard
G-Code
Timer Method
OK
OPEN/CLOSE
STANDBY/ON
7
1
★
(DVD-V70)
Before presetting your DVD-VCR:
◆ Switch on both the television and your DVD-VCR
◆ Check that the date and time are correct
◆ Insert the cassette on which the programme is to be
recorded (safety tab intact)
Up to six programmes can be preset.
1
Press the TIMER button.
Result:
The
TIMER METHOD
is displayed.
2
Press the corresponding
or
buttons, until the
G-Code
option
is selected.
3
Press the button to select
G-Code
.
Result:
A message is displayed to allow you to enter the
G-Code code.
☛
If all six programmes have been set, the message
Timer
is Full
is displayed. Refer to page 38 if you wish to
cancel a preset recording.
4
Press the numeric buttons to enter the code opposite the pro
gramme that you wish to record in your television magazine.
➢
If you wish to correct the G-Code code that you are
entering:
◆
Press the ¥ button until the digit to be corrected is
cleared
◆
Enter the correct digit
5
Press the OK button.
Result:
The information concerning the programme is displayed.
☛
When using the G-Code function for the first time with
stored stations, the programme number flashes. This one
time, you must enter the station number manually by
pressing the
or
buttons. Refer to the following page if:
◆
The programme number or times flash
◆
You wish to modify the programme
6
If the programme and times are correct, press the RETURN button.
7
Press the STANDBY/ON button to activate the timer.
8
Refer to page 38 if you wish to:
◆
Check that your VCR has been programmed correctly
◆
Cancel a preset recording
☛
The numbers next to each TV programme listing are
G-CODE code numbers, which allow you to programme
your videorecorder instantly with the remote control. Tap
in the G-CODE code for the programme you wish to
record.
™ G-CODE is a trademark of Gemstar Development Corporation. The G-CODE system is
manufactured under licence from Gemstar Development Corporation.
VCR
00169N DVD-V70/XSA-GB2 11/14/05 10:11 AM Page 35