Sony CMT-DH30 - Manual (Page 81)

CMT-DH3.GB.3-097-194-11(1)
1 GB
Additional I
nf
or
ma
tion
Additional Information
Troubleshooting
Should you encounter a problem with
your system, do the following:
1
Make sure the power cord and
speaker cords are connected
correctly and firmly.
2
Find your problem in the
troubleshooting checklist below and
take the indicated corrective action.
If the problem persists after doing all
of the above, consult your nearest Sony
dealer.
If the STANDBY indicator flashes
Immediately unplug the power cord,
and check the following items.
 If your system has a voltage
selector, is the voltage selector set
to the correct voltage?
 Are you using only the supplied
speakers?
 Is anything blocking the ventilation
holes on the rear of the system?
After the STANDBY indicator 
stops flashing, reconnect the power
cord, and turn on the system. If the
issue persists, contact your nearest
Sony dealer.
General
The clock or timer setting is canceled.
 The power cord is disconnected or a
power failure occurred. Redo “Setting
the clock” (page 23). If you have set
the timer, redo “Waking up to music”
(page 73).
“– –:– –” appears in the display.
 A power failure has occurred. Set the
clock (page 23) and timer settings
(page 73) again.
There is no sound.
 Press VOLUME +
 repeatedly.
 The headphones are connected to the
PHONES jack  .
 Check the speaker connections
(page 18).
 The system is in pause mode, in Slow-
motion Play or in Lock Search. Press
  (or DVD   on the unit) to
start the playback.
There is no microphone sound.
 Press VOLUME +
 repeatedly or
turn MIC LEVEL  on the unit
clockwise to adjust the microphone
volume.
 Make sure the microphone is
connected to the MIC jack 
correctly.
Continued
