Kenwood 715S - Manual (Page 18)

You can search for the station for any station if its name has
been preset using Station Name Preset.
Station Name Preset Play (SNPP)
(Function of Remote)
Continue steps 3 and 4 until all the characters are chosen for
the name.
You can enter up to 8 characters for each name.
Assigning Names
Press the NAME.S button on the unit or the OK button on the
remote.
The name of the station is stored in memory, and the Station
Name Preset mode ends.
Also, if you make no input for 10 seconds, the name will be
stored up to the point that you have entered, and the mode
ends.
• You can assign names to up to 32 FM stations and 16 AM
stations.
• All the station names will be erased if you press the RESET
button.
• If you want to change the name of a station, first display the
name of the station (following steps 1 and 2 above), then
change the letter(s) that you want by following steps 3 and 4.
NOTE
6
NOTE
5
Button to press # Times pressed Character
#3 1
1 #2
#6 2
#2 3
#3 2
“D”
“A”
“N”
“C”
“E”
You can assign names to radio stations with the Station Preset
Memory. Up to 32 FM stations and 16 AM stations can be
assigned names.
Adjust the frequency to the station whose name you want to
enter.
The station name preset function cannot be used when a
program service name or radio text is displayed.
Press the NAME.S button for at least two seconds.
"NAME SET" is displayed once the station name preset mode
is entered.
The cursor will blink in the position where letters are entered.
Press either the 4 or ¢ button to move the cursor to the
desired position.
The
4 button moves the cursor to the left, and the ¢
button to the right.
You can also move the cursor left or right by pressing the
4
or ¢ buttons, respectively, on the remote.
Each time the 38 button is pressed, the characters to be
entered change as listed below.
Press the FM or AM button to display the desired character.
Characters that can be displayed are as follows.
Direct Alphabet Input
Direct input can be made of letters (alphabetical) with the letter
entry buttons on the remote.
Example: Use the following table to enter the name "DANCE".
NOTE
Alphabet (upper case): A ~ Z
Alphabet (lower case): a ~ z
Numerals and symbols: 0~9 @ ” ‘ ` % & * + - = , . / \ < > [ ]
Special characters: б а й и н м у т ъ щ С З ® Я ‹ fl
в д к л о п ф ц ы ь с з © Ж › fi
4
3
2
NOTE
1
Station Name Preset (SNPS)
Tuner features
— 18 —
English
KDC-X715_U.S_r9 00.12.26 3:47 PM Page 18