Kenwood DPF-J9030 - Manual (Page 23)

23
Programming tracks in desired order (PGM mode) (Player A only)
Chapter 1
Chapter 2
Chapter 3
Chapter 4
Chapter 5
Chapter 6
Chapter 7
Use the following procedure to activate random playback
which selects a track at random after every track. This fea-
ture may allow you to play CDs for long hours without
getting tired of.
Preparation
÷ Select the Player A or Player B. *
Playback in a random order
(RANDOM mode)
1
Check that the Player is in the normal play
TRACK mode.
)
2
Select discs.
To select one disc
2Start playback.
Within 8 seconds!
1Select the disc number.
3Select “ONE DISC RANDOM”.
To select all discs
Select “ALL DISC RANDOM”.
÷ The disc number can be selected directly by using the DISC SELECTOR
and numeric buttons in place of the DISC SKIP (DOWN/UP) buttons.
To select another track in the middle of playing one To cancel random playback
÷ Pressing the 4 button once returns to the beginning of the track being
played.
÷ Press the 7 button to stop playback.
÷ Normal playback will be performed when RANDOM OFF is selected.
or
Select “RANDOM OFF”.
For random music type or random user file fi
DISC SKIP
DOWN UP
ENTER
6
RANDOM
F
RANDOM
F
CHARACTER
4 ¢
DOWN UP
7
RANDOM
F
For repeated playback
Press the REPEAT button to select “REPEAT ON”.
For continuous playback (ALL DISC RANDOM only)
Press the CONTINUOUS PLAY button.
> < < > < E < 1 0 > 2 > < >
Each press switches the modes as follows:
1 ONE DISC RANDOM
2 ALL DISC RANDOM
3 RANDOM OFF
The number here changes.
÷ Each time a track ends, the same operation as above is repeated,
and the track selected next is played.
÷ Random play stops after all of the tunes have been played once.
÷ If the selected disc is being played on the other Player, blinking
“DISCXXX BUSY!“ is displayed and the disc will not be played.
÷ If a track to be played is located in the disc played on the other Player,
that track will be skipped. (This track will not be selected later unless
the REPEAT mode is set.)
RANDOM
F
Previous disc Next disc
The 10-key remote is not capable of controlling Player B. It should
be controlled from the keyboard. Be sure to hold the ROOM B
button when controlling Player B.
÷ “ONE DISC RANDOM“ cannot be selected during the continuous play
mode.