Kenwood DPF-J9030 - Manual (Page 28)

28
Chapter 1
Chapter 2
Chapter 3
Chapter 4
Chapter 5
Chapter 6
Chapter 7
Select “SET DTS DISC“.
2
MODE
DISC SKIP
DOWN UP
SET
When playing DTS-encoded discs, excessive noise will be exhibited from the analog stereo outputs. If DTS discs are regis-
tered beforehand, the audio signal from the Player B (analog OUTPUT-B) is skipped. Use the following procedure before
playing the DTS disc.
1Press the MODE button.
÷ When the MODE button is pressed during DTS DISC SKIP mode, the
DTS DISC SKIP mode is cancelled.
Preparation
÷ Load DTS discs into the carousel. &
÷ Check that the Player A is in the normal play
TRACK mode. )
1
Activate the dts disc skip mode.
2Select “DTS DISC SKIP”.
Select the DTS disc.
3
Select the disc number.
÷ The disc number can be selected directly by using the numeric keys in
place of the DISC SKIP (DOWN/UP) buttons.
÷ To register another DTS disc, repeat the procedure from step 3.
DISPLAY-A
DISC SKIP
DOWN UP
Previous disc Next disc
\
To quit DTS DISC SKIP mode
Press the MODE button.
To delete the DTS registration
Use the following procedure before moving or changing a DTS disc, and register the disc again.
1Perform steps 1 of “Registration of DTS discs“.
2Select “CANCEL DTS DISC“.
DISC SKIP
DOWN UP
SET
\
3Select the DTS disc to be deleted.
SET
DISC SKIP
DOWN UP
Previous disc Next disc
\
To quit DTS DISC SKIP mode
Press the MODE button.
SET
Registration of DTS discs
\
DISC SKIP
DOWN UP
SET
\
Each press switches the modes as follows:
1 SET DTS DISC
2 CANCEL DTS DISC
Each press switches the modes as follows:
1 SET DTS DISC
2 CANCEL DTS DISC
Each press switches the modes as follows:
1 MUSIC TYPE
2 DISC SEARCH
3 TITLE INPUT
4 ALL DATA READ
5 ALL INFORMATION
6 DTS DISC SKIP
0 D 1 0 D I S T C U N A . C ?
0 D 1 0 D I S T S U T E A ? Y
DISPLAY-A
Note Note
When a DTS disc is played, the audio signal is not output at the analog OUTPUT A jacks.