Kenwood DPF-J9030 - Manual (Page 8)

8
Connecting to a Receiver or Amplifier
Chapter 1
Chapter 2
Chapter 3
Chapter 4
Chapter 5
Chapter 6
Chapter 7
System Control Chaining
System control allows you to :
÷ control connected devices via the receiver’s remote control
÷ switch the receiver’s input automatically to a connected device when you start playback from that device
÷ synchronize recording a CD or MD automatically when you start playback from those connected devices
What if I Have Several Kenwood Devices ?
1. If your amplifier or receiver does not support system control, do not connect the system control cable to any device.
2. Some CD players and cassette decks do not support the SL16 system control mode. Do not include these devices in a set of SL16 chained
connections.
3. Do not connect system control cables to any device not specified by Kenwood. Using system control functions with a device that does not
support them can damage the device.
4. Make sure system control plugs are firmly seated in the appropriate jacks.
Notes Notes
This unit is compatible only with the [SL16] mode. The system
control operation is not available if the unit is connected in the
[XS-8] connection mode.
Receiver or Amplifier
This unit
Cassette deck or MD
SYSTEM
CONTROL
SYSTEM
CONTROL
SYSTEM
CONTROL
÷ You can connect the system control cord to either system control
jack of the unit.
÷ If your component has the mode select switch, set the connected
components to the [SL16] mode.
(Ensure that the power plug is not connected.)