Kenwood VR-507 - Manual (Page 21)

21
Operations
Normal playback
1
Listening to a source component
Use the INPUT SELECTOR knob to select the source you
want to listen to.
The input sources change as shown below:
Selecting a source using the INPUT SELECTOR knob.
Adjusting the tone
You can adjust the sound quality when the receiver is in the PCM stereo
and analog stereo mode.
1 Press the SOUND key to select the tone mode to be adjusted.
• The bass and treble levels are adjustable from -10dB to +10dB in 2
step increments.
• The adjustment item is displayed for approximately 8 seconds.
2 Use the MULTI CONTROL knob or keys to adjust the sound
quality.
BASS: Select this to adjust the low frequency range.
(Press the SOUND key once.)
TREB: Select this to adjust the high frequency range.
(Press the SOUND key twice.)
FM
AM
MHz
kHz
PRO LOGIC
3
DOWN MIX
DIGITAL
S.DIRECT
MONITOR
DSP
MEMO
ST.
TUNED
AUTO SOUND AUTO
LFE
C
S RS LS
TI.VOL B
CLIP MUTE
RDS EON PTY
TP TA NEWS
SW
L SP A R
STEREO
Once-touch low frequency emphasis (bass boost)
(remote control only)
You can adjust the sound quality when the receiver is in the PCM stereo
and analog stereo modes.
Press the B. BOOST or BASS BOOST key.
• Press the key once to select the maximum (+10dB) low frequency
emphasis setting.
• This key does not function when the receiver is in the sound quality or
ambience effects adjustment mode.
Switching back to the previous setting
Press the B. BOOST or BASS BOOST key again.
Adjusting the sound
1 “PHONO”
2 “TUNER”
3 “ C D / D V D ”
4 “TAPE” or “MD”
5 “ V I D E O 1 ”
6 “ V I D E O 2 ”
7 “ V I D E O 3 ”
8 “ D V D / 6 c h ”
9 “AV AUX”
RC-R0720
INPUT
SELECTOR
INPUT
SELECTOR
INPUT SELECTOR
VOLUME CONTROL
VOLUME
VOLUME
RC-R0613
VOLUME
VOLUME SOUND SOUND
MUTE
MUTE
B. BOOST
MULTI
CONTROL MULTI
CONTROL
RC-R0613
RC-R0720
BASS
BOOST
SOUND
VOLUME CONTROL
SOURCE DIRECT
PHONES
SPEAKERS A/B
MULTI CONTROL
2
3
Start playback from the selected source.
Use the VOLUME CONTROL knob or VOLUME keys to
adjust the volume.
*5027/20-22/EN 3/15/01, 3:10 PM 21