Kodak i55 - Manual (Page 18)

14 A-61527 May 2006
SCSI connections IMPORTANT: Be sure the PC is off while you are doing the steps in
the “SCSI connections” section.
Connect the SCSI signal cable as shown below.
1. Attach a SCSI cable to the SCSI port.
NOTE: There are two SCSI ports on the scanner. This is a SCSI II
pass-through connection. Plug the SCSI cable into either
port using a 50-pin, high-density connector to connect to
the scanner.
2. Attach the other end of the SCSI cable to your PC SCSI port.
SCSI interface device ID Kodak does not recommend several devices on a SCSI chain with our
scanner. However, if there is more than one SCSI device on the chain,
you may need to adjust the SCSI ID selector on the scanner. This
selector assigns a specific device ID to the scanner. If the assignment
conflicts with an existing SCSI device, select a new ID.
NOTE: The factory SCSI ID setting for the scanner is 6. SCSI ID 0 is
usually assigned to an internal hard disk drive and 7, 8, and 9
are used for diagnostic purposes. The scanner will not operate
properly if the SCSI ID is set to 7, 8, or 9.
• Using a suitable tool, turn the SCSI ID selector switch until the arrow
points to the desired ID number.