Kodak i55 - Manual (Page 54)

50 A-61527 May 2006
The Options tab The Options tab allows you to set Image Transfer and Transport
control.
Image Transfer Order  if you are using simultaneous output
scanning (bi-tonal and color/grayscale) for either side, this option
controls the order in which the scanner returns image data. For
example, if you are scanning color and bi-tonal and you select Bi-tonal
Image, the scanner will return the bi-tonal front image, then the front
color image.
Transport Timeout  allows you to set a transport timeout value. This
value is the amount of time the scanner will wait after the last document
enters the transport before the transport timeout action is taken. You
can specify a time delay setting from 1 to 30 seconds.
Energy Saving Features of Scanner  allows you to set the amount
of time the scanner will remain inactive before the scanner goes into an
idle state. Choices are: (none) and 5 to 60 minutes. The default is 15
minutes.
Blank Image Detection — use the slider bar to specify the image size
(KB), below which an image is determined to be blank. Images with
sizes less than the size number you select will not be created. If you
use this option, you must specify a blank image size for each image
output type (Bi-tonal, Grayscale and Color) not just one. The default
for this option is None, which means that you will keep all images.