Kodak i55 - Manual (Page 78)

74 A-61527 May 2006
Replacing the input tray If the input tray needs to be reinstalled or replaced, use the following
procedure:
1. Remove the flatbed cover from the scanner by lifting the flatbed
cover straight up.
2. Raise the input tray as shown and gently lift the input tray out of the
slots.
To install a new input tray
1. Align the pins on the input tray with the slots on the flatbed cover (as
shown in the illustration above) and push the input tray into place.
2. Lower the input tray against the flatbed cover.
3. Replace the flatbed cover on the scanner.
Pins and slots