Kenwood KRF-V6020 - Manual (Page 11)

11
Preparations
KRF-V7020/V6020/V5020 (En/T)
SUB
WOOFER
SURROUND
PRE OUT
CENTER
L
R
SURROUND SPEAKERS
FRONT SPEAKERS
L R
+ + - -
+ + - -
L R
B
CENTER SPEAKER FRONT SPEAKERS
+ +
- -
R L C
A
SUB
WOOFER
SURROUND
PRE OUT
CENTER
L
R
CENTER
SPEAKER
FRONT
SPEAKERS
C L R
+
-
• Never short circuit the + and – speaker cords.
• If the left and right speakers are connected inversely or the speaker
cords are connected with reversed polarity, the sound will be unnatural
with ambiguous acoustic imaging. Be sure to connect the speakers
correctly.
1 Strip coating. 2 Loosen.
3 Insert. 4 Secure.
Connecting the speakers
Right
Front Speakers A
Left Right
Use the FRONT
SPEAKERS B
terminals if you
want to connect a
second front
speaker system.
(KRF-V5020 is not
equipped with
SPEAKERS B
terminal.)
Left
(Be sure to connect both
surround speakers)
Center Speaker
Surround Speakers
Powered
subwoofer
Speaker impedance
After confirming the speaker impedance indications printed on the
rear panel of the receiver, connect speakers with matching imped-
ance ratings. Using speakers with a rated impedance other than that
indicated on the rear panel of the receiver could result in malfunctions
or damage to the speakers or receiver.
Setting up the system
PRE OUT connections
This receiver has additional preout jacks. These can be used for
various purposes, but will need to be connected to an external power
amplifier as shown in the example below.
• Connecting a speaker cord directly to a PRE OUT jack will not
produce any sound from the speaker.
• To use the PRE OUT jacks, press the SPEAKERS A key to the on
position (the SPEAKERS key in the case of the KRF-V5020).
Power amplifier
Power amplifier
Surround
Speakers
Powered
Subwoofer
Center Speaker
The KRF-V5020 is
equipped with one-touch
speaker terminals.
They are arranged in the
same manner as the
speaker terminals of the
KRF-V7020 /KRF-V6020.
Refer to the instructions
on making connections to
the KRF-V7020/KRF-
V6020 when making con-
nections to the KRF-
V5020.
KRF-V7020, KRF-V6020 KRF-V5020
1 Strip coating. 2 Push lever.
3 Insert cord. 4 Return lever.