Konica Minolta DI3510 - Manual (Page 190)

9
Copy Paper
9-10 Di2510/Di3010/Di3510
Loading Paper Into the Multiple Bypass Tray
Use the multiple bypass tray when printing on plain paper, postcards,
envelopes, overhead projector transparencies and label sheets.
Copying onto the lower side of the set paper.
✎
Note
To set paper other than plain paper, settings must be made in the
panel.
While a copy job is being printed or queued, the paper size for the
multiple bypass tray cannot be set.
In addition, the “OHP Interleaving” function cannot be set at the same
time.
To load plain paper
1
Open the multiple bypass tray.
When loading large-sized paper,
open the tray extension.
2
Adjust the paper guides to fit the
size of the paper, and then insert
the paper as much as possible into
the feed slot.
✎
Note
Do not load so much paper that
the top of the stack is higher
than the Ä mark.
Make sure that the paper guides are pushed up against the edges
of the paper.
Tray extension
Paper guides