KTM 250 SX - Manual (Page 33)

4-5C
Dismounting of kickstarter
– Remove circlip 1 and kickstarter intermediate gear.
– Carefully release collar screw 2 kickstarter spring is tensioned, release
tension on kickstarter spring and unhook spring hanger.
! CAUTION !
C AREFULLY RELEASE THE KICKSTARTER SPRING ! D ANGER OF INJURY !
– Take the complete kickstarter shaft out of the housing.
– Take care of the stop disc, which could stay in the housing.
Dismounting of the shift lock
– Press the sliding plate 3 back with a screw driver so it no longer
engages with the driver for the shaft roller, at the same time remove
shift shaft from the housing.
NOTE: Watch the stop disc which remains in the housing.
– Remove allan head screw 4 and take driver for roller 5 and locking
piece 6 from the shift roller.
NOTE: From model 2002 driver for roller 5 and locking piece 6 are
made of aluminium.
NOTE: Disassemble locating lever only if the engine case must be
replaced.
– Remove screw 7 and locking lever with spring and bush.
Dismounting of ignition cover
– Undo the 5 screws and remove the ignition cover together with the
gasket.
1
2
3
4
5
6
7