LevelOne WCS-2000 - Manual (Page 6)

Physical Details
Figure 2: LevelOne IP Network Camera
Front-mounted LEDs
Ready On - Power on.
Off - No power.
Blinking - The Ready LED will blink during start up. This will take
15 to 20 seconds.
Active Off - Idle.
Blinking - LevelOne IP Network Camera is providing a live video
stream to at least one viewer.
LAN On - LAN port is active.
Off - LAN port is not available.
Blinking - Data is being transmitted or received via the LAN port.
Wireless
(WCS-2000 only) On - Wireless interface is active.
Off - Wireless interface is not available.
Blinking - Data is being transferred via the Wireless interface.
Rear Panel
Power Input Connect the supplied power adapter here.
LAN port Use a standard LAN cable to connect your LevelOne IP Network
Camera to a 10/100BaseT hub or switch.
Reset Button This button has two (2) functions:
• Restore Default IP Address. When pressed and released, the
LevelOne IP Network Camera will reset its IP address to the
default value
• Restore Default IP Address, Administrator ID, and
Administrator password. When pressed and held or 3
seconds, the IP address, Administrator ID, and Administrator
3