Regulatory information, Egulatory information – LevelOne IP Power Switch IPS-0008 User Manual
Page 42
Regulatory information
FCC Statement
This device complies with Part 15 of the FCC rules. Operation is subject to the following
conditions:
This device may not cause harmful interference; and
This device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a class B digital
device, pursuant to Part 15 of the Federal Communications Commission (FCC) rules.
These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
WARNING! The use of a shielded-type power cord is required in order to meet FCC
emission limits and to prevent interference to the nearby radio and television reception. It is
essential that only the supplied power cord be used. Use only shielded cables to connect
I/O devices to this equipment. You are cautioned that changes or modifications not
expressly approved by the party responsible for compliance could void your authority to
operate the equipment.
CE
This device complies with the EMC directive of the European Community and meets or
exceeds the following technical standards:
EN 55022 – "Limits and Methods of Measurement of Radio interference Characteristics
of Information Technology Equipment." This device complies with the CISPR Class B
standard.
EN 55024 – "Electromagnetic compatibility – Generic immunity standard, Part 1:
Residential, and light industry."
38