Philips CD360 - Manual (Page 5)

5
Active mobile phones in the vicinity may cause •
interference.
Metallic objects may be retained if placed near
•
or on the handset receiver.
SAVE THESE INSTRUCTIONS
•
Power requirements
This product requires an electrical supply •
of 120 volts AC. In case of power failure,
the communication can be lost.
The voltage on the network is classified
•
as TNV-3 (Telecommunication Network
Voltages), as defined in the standard UL
60950.
Warning
The Electrical network is classified as •
hazardous. The only way to power down the
charger is to unplug the power supply from
the electrical outlet. Ensure that the electrical
outlet is always easily accessible.
About operating and storage temperatures
Operate in a place where temperature is •
always between 0°C to +35°C (32°F to
95°F).
Store in a place where temperature is
•
always between -20°C and +45°C (-4° F
to 113° F).
Battery life may be shortened in low
•
temperature conditions.
Equipment approval
Information
Your telephone equipment is approved for
connection to the public switched telephone
network and is in compliance with parts
15 and 68, FCC Rules and Regulations and
the Technical Requirements for Telephone
Terminal Equipment published by ACTA.
1 Important safety
instructions
When using your telephone equipment, basic
safety precautions should always be followed
to reduce the risk of fire, electric shock and
injury to persons, including the following:
Caution
Use only the supplied batteries and adaptor •
Do not allow the charging contacts or the •
battery to come into contact with metal
objects.
Do not open the handset, base station or
•
charger as you could be exposed to high
voltages.
Do not allow the charger to come into contact
•
with liquids.
Risk of explosion if battery is replaced by an
•
incorrect type.
Dispose of used batteries according to the
•
instructions.
Always use the cables provided with the
•
product.
For pluggable equipment, the socket-outlet
•
shall be installed near the equipment and shall
be easily accessible.
Handsfree activation could suddenly increase
•
the volume in the earpiece to a very high level:
make sure the handset is not too close to your
ear.
This equipment is not designed to make
•
emergency calls when the power fails. An
alternative has to be made available to allow
emergency calls.
Do not expose the phone to excessive heat
•
caused by heating equipment or direct sunlight.
Do not drop your phone or allow objects to
•
fall on your phone.
Do not use any cleaning agents containing
•
alcohol, ammonia, benzene, or abrasives as
these may harm the set.
Do not use the product in places where there
•
are explosive hazards.
Do not let small metal objects come into
•
contact with the product. This can deteriorate
audio quality and damage the product.
English
EN