Panasonic KX-TC1871ALB - Manual (Page 24)

24
“ Preparing the Answering System
Programming Summary for the Answering
System
You can program the following functions using the handset near the
base unit. See the page numbers below for details.
The unit must be in the standby mode before programming.
≥ To cancel during programming, press
(FUNCTION/EXIT/CH)
. Start again from
the beginning.
≥ If 6 beeps sound during programming, a wrong key was pressed. Enter
the correct number.
Lift the handset, and press (FUNCTION/EXIT/CH) .
Press (›) or (‹) to select “ Program ”, and press FWD/EDIT
(fl)
( Yes key).
To adjust the day and time, press (0) . (page 25)
To set the remote code, press (1) . (page 77)
To select the number of rings, press (2) . (page 28)
To select the caller’s recording time, press (5) . (page 27)
To select the pager mode setting, press (6) . (page 74)
To store your home telephone number, press (7) . (page 72)
To store a pager number, press (#) . (page 71)
≥ The base unit display shows the setting of the selected adjustment or
function.
Press FWD/EDIT (fl) ( Save key).
≥ A beep sounds.
≥ To return to the standby mode, press (FUNCTION/EXIT/CH) .
≥ If the handset displays “ No link to base. Place on
cradle and try again. ” and an alarm tone sounds,
move closer to the base unit and try again.
Press (›) or (‹) to select “ TAD program ”, and press FWD/EDIT (fl)
( Yes key).
≥ “ Answering system setting. See base unit. ” is displayed on
the handset.
PQQX12877ZA-2 00.8.23 10:49 AM y [ W 24