Panasonic KX-TC1871ALB - Manual (Page 74)

74
“ Pager Call
Pager Mode Setting
After subscribing to a Caller ID service (p. 36), you can select one of
the following pager mode settings. The unit will alert your pager:
If you want to change the mode, proceed as follows.
1 Press (FUNCTION/EXIT/CH) .
2 Press (›) or (‹) repeatedly until the arrow
points to “ Program ”.
3 Press FWD/EDIT
(fl) ( Yes key).
4 Press (›) or (‹) repeatedly until the arrow
points to “ TAD program ”.
5 Press FWD/EDIT (fl) ( Yes key).
≥ The base unit display shows the answering
system function menu.
6 Press (6) .
≥ The current setting is displayed on the base
unit.
7 To select “Received call”, press (2) .
OR
To select “Recorded MSG”, press
(1) .
8 Press FWD/EDIT (fl) ( Save key).
≥ A beep sounds.
≥ To return to the standby mode, press (FUNCTION/EXIT/CH) .
≥ If you select “Received call” and set the unit to call your pager (p. 75), the unit
will alert your pager even if the answering system is not turned on.
≥ Even if you select “Received call”, the unit will not alert your pager when a
Caller ID call which does not have a phone number is received and the caller
does not leave any message.
Ringer volume
1 Program
43 1 =Yes
1 Save DIRECT#
Set recall time
43 1 =Yes
1 TAD program
43 1 =Yes
Answering
system setting.
See base unit.
Pager mode
:Recorded MSG
Base unit display
Recorded MSG: After the unit records an incoming message
(factory preset),
OR
Received call:
Each time the unit receives a Caller ID call, even
if the caller does not leave a message.
PQQX12877ZA-5 00.8.23 10:53 AM y [ W 74