Panasonic KX-TC1871ALB - Manual (Page 90)

Before Requesting Help
90
Problem
“ No link to base.
Place on cradle and
try again. ” is displayed
and an alarm tone sounds.
Static, sound cuts in/out,
fades. Interference from
other electrical units.
The handset and/or the base
unit do not ring.
The handset display is
blank.
The handset display is still
blank after pressing
(›) ,
(‹) , BACK
(fi) or
FWD/EDIT
(fl) .
You cannot store a name
and phone number in the
directory.
While programming or
searching, the unit starts to
ring and stops the program/
search.
Cause and Remedy
≥ You are too far from the base unit.
Move closer and try again.
≥ Place the handset on the base unit and
try again.
≥ Plug in the AC adaptor.
≥ Raise the base unit antenna.
≥ Locate the handset and the base unit
away from other electrical appliances
(p. 3).
≥ Move closer to the base unit.
≥ Raise the base unit antenna.
≥ Press (FUNCTION/EXIT/CH) to select
a clearer channel.
≥ The ringer volume is set to OFF. Set to
HIGH or LOW (p. 20, 21).
≥ If the line is connected to a low voltage
system such as a PBX, the unit may not
ring. Set the line mode to “B” (p. 17).
≥ The handset is in the standby mode
(p. 16). Press
(›) , (‹) , BACK (fi) or
FWD/EDIT (fl) to turn the display on.
≥ Charge the battery fully (p. 15).
≥ You cannot store an item in the
directory while the unit is in the talk,
speakerphone or intercom mode, or
while the answering system is in use.
≥ Do not pause for over 60 seconds while
storing.
≥ To answer the call, press (TALK) or
(DIGITAL\SP-PHONE) . Start again from
the beginning after hanging up.
Cordless Telephone
PQQX12877ZA-6 00.8.23 10:54 AM y [ W 90