Panasonic PVQ-2012 - Manual (Page 8)

8
For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : [email protected]
Connections/ Initial Setup
(Ready to Play)
How to Connect
VHF/UHF
VHF/UHF
UNIT
IN from
ANT./CABLE
VHF/UHF
VHF/UHF
VHF/UHF
Cable TV
Converter Box
IN from
ANT./CABLE
2 / 6 / 2002 WED 12 : 00PM
DST : ON
AUTO CLOCK SET
COMPLETED
SETT I NG : CH 1 0
If AUTO CLOCK SET IS
INCOMPLETE screen
appears, set the clock using
MANUAL CLOCK SET
procedure on next page.
Initial Setup (Ready to Play)
1
Plug the unit power cord into an
AC wall outlet.
Press Power* on the remote or
unit. The unit comes on and auto
channel and clock set starts.
• If you use a cable box, turn it on and set it to the
Public Broadcasting Service (PBS) channel in
your time zone. If you use a DSS reciever, it
must be turned off.
Settings are made
automatically. When setup is
done, this screen appears.
For ANT./Cable
Connect the cable from
Antenna/Cable to the VHF/UHF
terminal on the unit.
For DSS/Cable Box
Connect the OUT jack on your
cable box to the VHF/UHF
terminal on the unit with a RF
cable.
WARNING:
Overtightening "Nut type" RF coaxial cables
may damage jacks. Finger tighten only.
Please make all cable or antenna connections before plugging into
the AC outlet. Plugging the unit power cord into an AC outlet starts
auto channel and clock set.
CH AUTO SET PROCEEDING
PROCEEDING
AUTO CLOCK SET
CANCEL : PRESS STOP KEY
3
Connecting
2
PLEASE SET CLOCK BY
PRESS I NG ACT I ON KEY
AUTO CLOCK SET
I S I NCOMPLETE