Polycom SpectraLink SCM408 - Manual (Page 44)

SpectraLink 6100 MCU: Installation and Operation: SpectraLink 6000 System
PN: 1725-36097-001_L.doc 44
Program Handset Features
PBX and Key Systems provide users with special features such as
hold, transfer, conference, camp on, and speed dial. These features
can be accessed via the handset, but the telephone system or
SpectraLink 6100 MCU must be programmed to allow access to these
features from the handset. For information on programming the
switch to operate with the handsets, refer to the system
administration document for your PBX.
• If the SpectraLink 6100 MCU is connected to your telephone
system via analog lines, refer to your analog system’s feature
programming document.
• If the SpectraLink 6100 MCU is connected to a digital key
telephone system or PBX, refer to your digital system’s feature
programming document.
Test Handsets
Verify proper registration and operation of each handset by
performing the following steps.
1. Press the
START key on each handset. The extension number
should clear and you should hear dial tone. On some digital
systems, depending on how the telephone system is programmed,
you may have to select a line to get dial tone.
2. Place a call to each handset to verify ring, answer, clear transmit,
and clear receive audio.
3. Verify all programmed features on each handset.
4. Press the
END key. The LINE indicator should turn off.