Preparing cables and making connection, Preventing the speakers from falling – Panasonic SC-BTT370 User Manual

Page 11

Advertising
background image

Getting s

tar

te

d

11

VQT3D27

[BTT370] [BTT273]

1

Use of the speaker cable stickers is
convenient when making cable connections.

e.g. Front speaker (L)

A Speaker cable sticker (supplied)
B Connector

Be sure to match the number on each sticker with the
connector color.

2

Connecting the speaker cables. Insert the
wire fully, taking care not to insert beyond
the wire insulation.

≥ [BTT770] Be sure to use the speaker cables that have a

large connector and short cable when you use the
wireless system.

e.g. Surround speaker

Be careful not to cross (short-circuit) or reverse the polarity of the speaker wires as doing so may damage the speakers.
Don’t use a front speaker as a surround speaker or vice versa. Verify the type of speaker with the label on the rear of the speaker before

connecting the appropriate cable.

≥ To avoid injury by falling or dropping the speaker, place the speaker cables with care not to stumble or hook.
≥ Do not hold the speaker in one hand to avoid injury by dropping the speaker when carrying.

[BTT770] [BTT370] [BTT273]

∫ Preventing the speakers from falling

≥ Consult a qualified housing contractor concerning the appropriate procedure when attaching to a concrete wall or a surface that

may not have strong enough support. Improper attachment may result in damage to the wall or speakers.

≥ Use a string of less than ‰ 2.0 mm (

3

/

32

q), which is capable of supporting over 10 kg (22 lbs).

e.g., [BTT770]

A String (not supplied)

Thread from the wall to the speaker and tie tightly.

B Rear of the speaker
C Screw eye (not supplied)
D Wall
E Approx.150 mm (5

29

/

32

q)

Preparing cables and making connection

Thread the speaker cable
through the base.

≥ Use cables with a white connector

and red connector.

Leave about
110 mm (4

11

/

32

q)

Insert the wire fully.
r: White
s: Blue line

Press into the groove.

Tighten securely.

Pull the cable
straight along the
line and slide into the
groove.

Push!

Back of the base

Speaker cable sticker

Color

1 FRONT (L)

WHITE

2 FRONT (R)

RED

3 SURROUND (L)

BLUE

4 SURROUND (R)

GRAY

5 CENTER

GREEN

6 SUBWOOFER

PURPLE

FRONT

Lch

Push!

r: White
s: Blue line

VQT3D27~Body_mst.fm 11 ページ 2011年1月6日 木曜日 午後1時33分

Advertising
This manual is related to the following products: