Panasonic SC-BTT370 - Manual (Page 45)

Reference
45
VQT3D27
Distorted sound or noise is heard.
≥ Adjust the position of the antenna.
≥ Use an outdoor antenna. (
16)
A beat sound is heard.
≥ Try to keep a certain amount of distance between the
antenna and the TV.
No power.
≥ Ensure the AC power supply cord of the wireless system is
connected properly.
The wireless link indicator is flashing.
≥ There is no link between the main unit and the wireless
system. Turn the wireless system off and then back on.
Alternatively, turn the wireless system off, disconnect the AC
power supply cord and then reconnect it.
The wireless link indicator does not light.
≥ Check that the main unit is turned on, and the wireless
system is turned on.
≥ Ensure that the digital transmitter is fully inserted into the slot
of the main unit. ( 17)
The wireless link indicator keeps flashing between red and
green.
≥ There is a power supply problem. Consult the dealer.
I can’t connect to the network.
≥ Confirm the network connection and settings. (
17, 20, 40)
≥ Check the operating instructions for each device and
connect accordingly.
BD-Video or DVD-Video is not played.
≥ Ensure the disc is for the correct BD-Video region code or
DVD-Video region number, and is not defective. ( 8)
≥ You have set a ratings level to limit BD-Video or DVD-Video
play. Change this setting. ( 37)
≥ Some BD-Video can only be output with HDMI.
I cannot play back BD-Live.
≥ The SD card is write-protected. (
9)
≥ Confirm that this unit is connected to the broadband Internet.
( 17)
≥ Confirm the “BD-Live Internet Access” settings. ( 37)
≥ Confirm an SD Card is inserted into the SD Card slot. ( 22)
Alternative soundtrack and subtitles cannot be selected.
≥ The languages are not recorded on the disc.
≥ You may not be able to use the playback menu to change the
soundtrack and subtitles on some discs. Use the disc’s
menus to make changes. (
25)
Angle cannot be changed.
≥ Angles can only be changed during scenes where different
angles are recorded.
Messages
The following messages or service numbers appear on the
television or unit’s display when something unusual is detected
during startup and use.
Cannot play.
≥ You inserted an incompatible disc. (Discs recorded in PAL
video, etc.)
Cannot display on this unit.
≥ You tried to play a non-compatible image.
No disc is inserted.
≥ The disc may be upside down.
$ This operation is not available.
≥ Some operations are unsupported by the unit. For example;
jBD-Video: During playback, reverse slow-motion or
reverse frame-by-frame is not possible.
IP address is not set.
≥ The “IP Address” in “IP Address / DNS Settings” is “---. ---.
---. ---”. Set the “IP Address”, “Subnet Mask”, and “Default
Gateway”. (Select the automatic address acquisition if
necessary.)
No Video
≥ Depending on the connected iPod/iPhone, video menu may
not be available on the TV. Select “ALL” on the unit’s display
and operate video playback from your iPod/iPhone menu.
(
34)
F99
≥ The unit fails to operate properly. Press [POWER Í/I] on the
main unit to switch the unit to standby for 3 seconds. Now
press [POWER Í/I] on the main unit again to turn the unit
on.
U59
≥ The unit is hot.
The unit switches to standby for safety reasons. Wait for
about 30 minutes until the message disappears.
Select a position with good ventilation when installing the
unit. Do not block the ventilation hole on the rear and side of
the unit.
HDMI ONLY
≥ Some BD-Video discs can only be output with HDMI.
NET
≥ While connecting to a network.
Radio
[BTT770]
Wireless system (SH-FX71)
Network
Other difficulties with playback
On the television
On the unit’s display
SC-BTT770_370_270P_eng.book 45 ページ ２０１０年１２月２４日 金曜日 午前１０時５７分