Panasonic KX-FPG377 - Manual (Page 63)

8. Programmable Features
61
“ERROR” (default): A sending report will be
printed only when fax transmission fails.
“ON”: A sending report will be printed out after
every transmission.
“OFF”: Sending reports will not be printed out.
Code #06: Changing the ring setting in FAX
ONLY mode
FAX RING COUNT
RINGS=3
[
±]
To change the number of rings before the unit
answers a call in FAX ONLY mode.
You can select “1”, “2”, “3” (default) or “4”.
Code #06: Changing the ring setting in
TAM/FAX mode (Telephone Answering
Machine/Fax mode)
TAM RING COUNT
RINGS=2
[
±]
To change the number of rings before the unit
answers a call in TAM/FAX mode. You can select
“1”, “2” (default), “3”, “4”, “TOLL SAVER” or
“RINGER OFF”. See page 46 for details.
Code #10: Changing the maximum recording
time for incoming messages
RECORDING TIME
MODE=VOX
[
±]
“VOX” (default): Unlimited.
“1 MIN”: Up to 1 minute.
Code #11: Setting the remote operation ID
REMOTE TAM ID
ID=111
1. Press {MENU}.
2. Press {#}, then {1}{1}.
3. Enter any 3-digit number except a number
using 0 or 7.
L The default ID is “111”.
4. Press {SET}.
5. Press {MENU}.
Code #13: Setting the dialing mode
DIALING MODE
MODE=TONE
[
±]
If you cannot make calls, change this setting
depending on your telephone line service.
“TONE” (default): For tone dial service.
“PULSE”: For rotary pulse dial service.
Code #16: Setting the recording paper size
PAPER SIZE
=LETTER
[
±]
“LETTER” (default): Letter or legal size paper.
“A4”: A4 size paper.
Code #17: Setting the ringer pattern
RINGER PATTERN
MODE=A
[
±]
You can select from “A” (default), “B” or “C”.
8.3 Advanced features
Code #22: Setting the journal report to print
automatically
AUTO JOURNAL
MODE=ON
[
±]
“ON” (default): The unit will print a journal report
automatically after every 30 new fax
communications (page 41).
“OFF”: The unit will not print a journal report, but
will keep a record of the last 30 fax
communications.
Code #23: Sending documents overseas
OVERSEAS MODE
MODE=ERROR
[
±]
If you cannot send a fax overseas even if the
number is correct and the line is connected,
activate this feature before starting transmission.
“NEXT FAX”: This setting is effective only for the
next attempted fax transmission. After
transmission, the unit will return to the previous
setting.
“ERROR” (default): When the previous fax
transmission fails and you wish to re-send the
document automatically.
“OFF”: Deactivates this feature.
Note:
L This feature is not available for broadcast
transmission.
L The calling charge may be higher as the
transmission speed is slowed down.
Code #25: Sending a fax at a specific time
DELAYED SEND
MODE=OFF
[
±]
This feature allows you to take advantage of low-
cost calling hours offered by your telephone
company. This feature can be set up to 24 hours
in advance of the desired time.
To send a document:
FPG376.book Page 61 Wednesday, July 30, 2003 6:28 PM