Panasonic TH-32LHD7 - Manual (Page 9)

9
Connections
SERIAL PC IN
AUDIO
SLOT1 SLOT2
VIDEO IN VIDEO OUT AUDIO
IN
R L
AV S VIDEO IN
VIDEO IN AUDIO IN L R S VIDEO IN
SLOT 2
AV VD HD PR/CR/R PB/CB/B Y/G R AUDIO L COMPONENT/RGB IN
SLOT 1
AUDIO
PC IN SERIAL
VIDEO OUT
1 2
COMPONENT/RGB IN
P R /C R /R P B /C B /B VD HD Y/G R AUDIO L
1
2
1
2 SPEAKERS
Terminals (R)
SPEAKERS
Terminals (L)
– Cable fi xing bands
Secure any excess cables with bands as required.
When connecting the speakers, be sure to use only the optional accessory speakers.
Refer to the speaker’s Installation Manual for details on speaker installation.
Speakers (Optional accessories)
Pass the attached cable
fi xing band through the
clip as shown in the
fi gure. To secure cables connected to Terminals, wrap the cable fi xing band around them
then pass the pointed end through the locking block, as shown in the fi gure.
While ensuring there is suffi cient slack in cables to minimize stress (especially
in the power cord), fi rmly bind all cables with the supplied fi xing band.
From SERIAL Terminal
on Computer
(see page 11)
From EXTERNAL
monitor terminal on
Computer (see page 10)
AC cord connection (see page 12)
To tighten:
To loosen:
Pull
Pull
Push the catch
3. Slide up the clamper and fi x
the AC cord plug securely.
2. I n s e r t t h e A C c o r d
and close the clamper
securely.
1. Open the clamper.
Clamper AC cord
Note: The power plug in the illustration may not be the type fi tted to your set.
When loosen
the clamper:
Optional Terminal Board insert Slots (covered)
– AC cord fi xing
4. Insert the point of the
fixed clamper into the
small hole on the lower
r i g h t o f
t h e b a c k
c o v e r a s
necessary.