Panasonic DIGA DMR-EZ48V - Manual (Page 6)

6
RQT9056
Control Reference Guide
 Cassette eject button .....................................( 15)
 Disc tray open/close button ............................( 15)
 Stop button ...............................................( 17, 18)
 Play/ 1.3 button ............................................( 17)
 Channel select button ....................................( 13)
 Recording button ............................................( 18)
 DVD/VHS POWER on/off button
( /I POWER) ................................................( 12)
 Press to switch the unit from on to standby mode or vice
versa. In the standby mode, the unit is still consuming a small
amount of power.
 IN2 input terminals ........................................( 28)
 DVD/VHS drive indicator ................................( 17)
 Lights when the DVD or VHS drive is selected.
 Drive select button .........................................( 17)
 Drive changes each time you press [DRIVE SELECT].
 Reset button ...................................................( 81)
 DV IN terminal (for a digital video
camcorder) .....................................................( 29)
 SD card slot ....................................................( 15)
 USB port ........................................................( 15)
 One touch copying operation button
 From VHS to DVD ...................................................... ( 20)
 From DVD to VHS ...................................................... ( 21)
 Recording indicator
 TV indicator
The indicator lights during TV mode and it goes out during VCR
mode. You can switch the mode by using [VCR/TV] (
16).
 Main display section
 Tape indicator
 Progressive indicator
This indicator lights up when you select “24p” in “Progressive/
24p” (
51).
 Scheduled recording indicator ( 19)
On:
When a scheduled recording program is registered and a
recordable disc or tape is inserted.
Flashes:
The scheduled recording indicator fl ashes when the unit cannot
go to scheduled recording standby (e.g. there is no disc or tape,
etc). It does not fl ash if Quick Start is off.
 Disc indicator
This indicator lights up when a disc that is supported by this unit
is inserted.
The Unit’s Display
Main Unit
S VIDEO IN 2 VIDEO /MONO AUDIO R L S VIDEO IN 2 VIDEO /MONO AUDIO R L
OPEN/CLOSE EJECT
POWER
REC
SD CARD
CH CH
DRIVE SELECT
RESET
      
COPYING COPYING
COPYING COPYING
REC CH CH
Cassette
compartment
The unit’s display
Remote Control
signal sensor
Disc tray
Opening
the front panel Pull down.