Philips AQ95-56F-1224KR - Manual (Page 16)

16
Mute the microphone
1
Press during a call.
The handset displays » [MUTE ON].
The caller cannot hear you, but you »
can still hear his voice.
2
Press again to unmute the microphone.
You can now communicate with the »
caller.
Turn the speaker on or off
Press .
Make a second call
Note
This service is network dependent. •
1
Press during a call.
The first call is put on hold. »
2
Dial the second number.
The number displayed on the screen is »
dialed out.
Answer a second call
Note
This service is network dependent. •
When there is a periodical beep to notify you
of an incoming call, you can answer the call in
these ways:
1
Press and to answer the call.
The first call is put on hold, and you »
are now connected to the second call.
End a call
You can end a call in these ways:
Press • ; or
Place the handset to the base station •
or charging cradle if the auto hang up
is activated.
Answer a call
When the phone rings, press or to
answer the call.
Warning
When the handset rings or when the •
handsfree is activated, keep the handset away
from your ear to avoid ear damage.
Note
The caller ID service is available if you have •
registered to the caller ID service with your
service provider.
Tip
When there is a missed call, the handset •
displays a notification message.
Turn off the ringer for all incoming
calls
There are two ways to turn off the ringer:
1
Press and hold in standby mode.
» displays on the screen.
2
When the phone rings, press .
Adjust the earpiece volume
Press or to adjust the volume during a call.
The earpiece volume is adjusted and »
the phone is back to the call screen.
EN
IFU_CD270-275_05_EN.indd 16 1/5/2010 5:32:59 PM