Panasonic KX-TG1034 - Manual (Page 9)

Preparation
For assistance, please visit http://www.panasonic.com/help 9
Setting up the base
unit
Connecting the AC adaptor
and telephone line cord
Connect the telephone line cord until it
clicks into the base unit and telephone
line jack (
A). Connect the AC adaptor
cord ( B) by pressing the plug firmly
( C).
L
Use only the included Panasonic AC
adaptor PQLV207.
Note:
L
The AC adaptor must remain
connected at all times. (It is normal for
the adaptor to feel warm during use.)
L The AC adaptor should be connected
to a vertically oriented or floor-
mounted AC outlet. Do not connect
the AC adaptor to a ceiling-mounted
AC outlet, as the weight of the
adaptor may cause it to become
disconnected.
L The unit will not work during a power
failure. We recommend connecting a
corded telephone to the same
telephone line or to the same
telephone line jack using a Panasonic
T-adaptor (page 5).
If you subscribe to a DSL service
Please attach a noise filter (contact your
DSL provider) to the telephone line
between the base unit and the
telephone line jack in the event of the
following:
– Noise is heard during conversations.
– Caller ID features do not function
properly.
Setting up the handset
Connecting the AC adaptor
L Use only the included Panasonic AC
adaptor PQLV209.
To single-line
telephone jack
(RJ11C)
A
B
(120 V AC,
60 Hz)
Hook
C
Noise filter
To single-line
telephone
jack (RJ11C)
(120 V AC, 60 Hz)
Fasten the AC adaptor cord to
prevent it from being disconnected.
Bottom of the charger
Hooks
Hooks