Precor EFX 5.23 - Manual (Page 3)

EFX 5.21/ 5.23 Elliptical Fitness Crosstrainer Assembly Guide 1
Thank you for choosing Precor. For proper installation, please read this guide
thoroughly and follow the assembly instructions. If you do not assemble the EFX
according to these guidelines, you could void the Precor Limited Warranty.
Obtaining Service
You should not attempt to service the EFX except for maintenance tasks
described in the owner’s manual. Should you need more information regarding
Customer Support numbers or a list of Precor authorized Service Centers, visit
the Precor web site at www.precor.com.
Unpacking the Equipment
The EFX is carefully tested and inspected before shipment. The unit is shipped in
one box. Ask for help to unpack and assemble the EFX. If any items are missing,
contact your dealer.
Important: (240 volt 5.23 model only) If the power cord attached to your
equipment is not compatible with your local power plug standards, the container
should also include a power cord for your region. You will need to install this
cord in place of the one attached to the equipment. If you need such a cord and
it was not included with your EFX, please contact your Precor dealer for the
correct Precor power cord. For a list of authorized Precor dealers in your area,
please contact Customer Support at www.Precor.com.
Required Tools
• Wire cutter
• Rubber mallet (EFX 5.23 only)
• Philips head screwdriver
Installation Requirements
Follow these installation requirements when assembling the unit:
• Assemble the EFX in the location where you plan to use it. No rollers or
wheels exist on the EFX, so it is not easy to move once it is fully
assembled.
• Provide ample space around the unit.
Important: Consult your owner’s manual for proper placement of your
equipment.
• Set up the unit on a solid, flat surface.
A smooth, flat surface under the unit helps keep it level. A level unit has fewer
malfunctions.
• Open the box and assemble the components in the sequence presented
in this guide.
• Obtain assistance.
Ask another capable adult for assistance during the assembly process.
• Use your fingers or the appropriate tools to insert fasteners.
Proper alignment helps alleviate cross-threading. Do not fully tighten
fasteners until instructed to do so.
When fully tightened, the head of the fastener should be flush with the
product. If it is not, cross-threading has occurred. Do not attempt to rework
the assembly as more damage to the equipment will occur. Contact
Customer Support. Refer to Obtaining Service.