Quadpacer, Cord wrap on deluxe charger (select models) – Philips sonic toothbrush FlexCare 900 User Manual

Page 9

Advertising
background image

Smartimer
The Smartimer indicates that your brushing cycle is complete by

automatically turning off the toothbrush at the end of the brushing cycle.

Dental professionals recommend brushing no less than 2 minutes twice a

day.xQuadpacer

The Quadpacer is an interval timer that has a short beep and pause to

remind you to brush the 4 sections of your mouth. Depending on the

brushing mode or brushing routine you have selected, the Quadpacer

beeps at different intervals during the brushing cycle. See the “Brushing

instructions” and “Personalizing your brushing experience” sections.

The Quadpacer feature on this model has been activated. To deactivate or

reactivate the Quadpacer feature:

1

Place the handle with a brush head attached in the plugged-in

charger.



To deactivate Quadpacer: Press and hold the Personalized brushing

button for  seconds. You hear 1 beep to indicate the Quadpacer has

been deactivated.

To reactivate Quadpacer: Press and hold the Personalized brushing

button for  seconds until you hear  beeps. This indicates that the

Quadpacer feature is active again.

Note: The Quadpacer feature cannot be deactivated on the pre-programmed

Go Care and Max Care brushing routines.
Cord wrap on deluxe charger (select models)
If your model includes the deluxe charger cover and base, the travel

charger is pre-installed inside the cover. If you want to shorten the power

cord, you can store excess cord in the cord wrap feature built into the

charger base.

1

To separate the charger cover from the charger base, press the two

gray snap bars on the charger base and pull the white charger cover

upwards.



Wrap excess power cord around the gray charger base as shown in

the picture. Be sure to wrap the cord on the inside of the two snap

levers.

-

,

1

2

4

3

1

2

4

3

EngliSh



Advertising
This manual is related to the following products: