Paradyne 8310 MVLt - Manual (Page 97)

B-1 8000-A2-GB26-10 January 1999
Traps
B
DSL Card Traps
Traps are configured via a Telnet or terminal session. The addition or removal of
a card or another hardware component within the Hotwire DSLAM system causes
a trap to be generated. These traps indicate a configuration change notification
(CCN) of a card (a hardware replacement or a software upgrade).
Event Severity Comment Trap # MIB
CCN
(Configuration
Change Notice) warning Configuration change caused
by one the following events:
H Software download.
H Configuration download.
H Card removed (objective).
7 hot_sys.mib
(Enterprise MIB)
warning Configuration change affecting
the entity MIB. 1 hot_domain.mib
(Enterprise MIB)
Cold start warning Card has been reset and
performed a cold start. 0 MIB II
(RFC 1213)
Configuration
download
failure warning Configuration download has
failed. 2 hot_diag.mib
(Enterprise MIB)
Device failure major Access Node’s software has
detected an internal device
failure. 15 hot_sys.mib
(Enterprise MIB)
DHCP filter
security failure minor Cannot add new route; route
table contains maximum
number of rules. 11 hot_dhcp.mib
(Enterprise MIB)
xDSL link up or
down
or
Transitions
threshold
exceeded
minor Number of link down events
above threshold. This rate is
limited to once every 15
minutes. 1 hot_xdsl.mib
(Enterprise MIB)
xDSL margin
low minor Margin estimate below
customer set threshold. 3 hot_xdsl.mib
(Enterprise MIB)