Panasonic RX-D29 - Manual (Page 6)

6
RQTT0585
Listening to radio broadcasts
Normal tuning Preset tuning
1 2 3 4
1 2 3
2
1
RX-D29
RX-D27
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
4 Adjust the volume.
To improve reception
FM: Extend the whip antenna and adjust its direction.
AM: Adjust the position of the unit.
If noise is excessive in the FM stereo mode
Press [PLAY MODE] on the remote control.
(“MONO” lights up.)
Sound will be produced in monaural, but this
also reduces noise.
Press the button again to cancel. (“MONO”
goes out.)
1 Press [TUNER/BAND –AUTO PRESET] to select “FM” or
“AM”.
(Unit comes on.)
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
2 (Omit this step if using the remote control)
If “ ” is on the display, press
[TUNE MODE] to clear it.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
3 Press [– / ] or [ / +] to tune
to the desired station.
Automatic tuning
Press and hold [–/ ] or [ /+] then release when the frequency
display starts to change. A station with good reception is automati-
cally selected and the process stops.
To stop automatic tuning, press [–/
] or [ /+] again.
Note
Automatic tuning may stop on a frequency where there is no station
if there is interference. Press [–/
] and [ /+] to tune if this occurs.
Automatic presetting
Do the following once each for FM and AM.
Preparations: Press [TUNER/BAND –AUTO PRESET] to select “FM” or
“AM”.
Press and hold [TUNER/BAND –AUTO PRESET] on the main
unit until “AUTO” is displayed.
The tuner presets stations it can receive into the channels.
Remote control only
Presets one station at a time.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
1 Press [PGM/CLEAR].
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
2 While “ ” is flashing (about 10
seconds)
Press the numbered buttons to
select a channel.
To select channel 10 or higher
e.g.12: [ = 10] → [1] → [2] >
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Repeat the above to preset other stations.
The station occupying a channel is erased if another station is preset in
that channel.
Manual Presetting
Press [TUNER/BAND –AUTO PRESET] to select “FM” or
“AM”.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
(Omit this step if using the remote control)
Press [TUNE MODE] to display
“
”.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Press [– / ] or [ / +] to select
the desired channel.
(FM:1-20, AM:1-12)
Remote control:
[ / ALBUM]( PRESET TUNE)
or [ALBUM / ](PRESET TUNE )
To listen to preset channels
Preset channel
1
2
3
Preset the stations (20 FM and 12 AM) to make tuning simpler.