Philips UCZZ01930AB - Manual (Page 20)

18 Using your phone
4.1.7 Call using Direct Access
Memory
In idle mode, long press
1 or 2 to
dial a stored direct access memory
number.
See section 5.5.6 for instructions on how
to store, edit, and delete direct access
memory numbers.
4.1.8 Enter a Dialing Pause
Make a long press
# after entering one
or more digits to enter a pause in the
dialling sequence.
4.2 Answer a call
When the handset rings during an
incoming call, please do not hold the
handset too close to your ear as the
volume of the ringing tone may damage
your hearing.
When the phone rings, press
t.
• The call is established.
Incoming call has priority over other
events. Whenever there is an incoming
call, other status in progress such as
phone setting, menu navigation, etc will
be aborted.
4.2.1 Handsfree answering
Handsfree activation can suddenly
increase the volume in the earpiece to a
very high level. Make sure the handset is
not too close to your ear.
When the phone rings, press
l.
• The handset loudspeaker is activated.
4.2.2 Call waiting
If you have subscribed to Call Waiting
services, the earpiece will emit a beep
tone to inform you that there is a second
incoming call. The number or name of
the second caller will also be displayed if
you have subscribed to Caller Line
Identification service (CLI). Please
contact your network provider for more
information on this service.
To answer the second call, press
t and
then
2 to answer the call.
• The first call is put on hold, and you
are now connected to the second call.
OR
Press
t and then 1 to end the
current call and answer the second call.
4.3 End a call
To end a conversation, press
h.
• The call ends.
When auto hang-up is on, you can simply
place the handset back to its base station
or charger to end the call. This feature is
activated by default.
The call duration (MM-SS) will be
displayed on the handset screen for
about 5 seconds.
Note
Danger
Note
Danger
Tip
Note