Philips UCZZ01930AB - Manual (Page 34)

32 Advanced settings
1
Press
m in idle mode, scroll n to
ADVANCED SET and press
o.
2
Scroll
n to RECALL TIME and
press
o
3
Scroll
n to SHORT or LONG
and press
o to confirm.
• A validation tone is emitted and
the screen returns to the
previous menu.
The use of your phone cannot be
guaranteed on all PABX.
7.8 Change the Dial Mode
The default value for dial mode that is
preset in your handset should be the best
suited for your country network and
therefore you should not need to change
it.
1
Press
m in idle mode, scroll n to
ADVANCED SET and press
o,
scroll
n to DIAL MODE and
press
o.
2
Scroll
n to TONE or PULSE and
press
o to confirm.
• A validation tone is emitted and
the screen returns to the
previous menu.
7.9 Set First Ring Detection
First ring detection allows the phone to
ring upon reception of the first ring
signal. It is recommended that you set
first ring detection OFF if you subscribe
to caller line identification service. If you
do not subscribe to caller line
identification service, it is recommended
that you set first ring detection ON. (See
Section 6.2.2.)
1
Press
m in idle mode, scroll n to
ADVANCED SET, and press
o.
2
Scroll
n to FIRST RING and
press
o.
3
Scroll
n to ON or OFF and press
o to confirm.
• A validation tone is emitted and
the screen returns to the
previous higher menu level.
7.10 Default settings
Note
Parameter Default Value
Ring Volume LEVEL 3
Ring Melody MELODY 1
Earpiece/
Speaker
Volume Medium (VOLUME 3)
Key Beep ON
Display
Language COUNTRY
DEPENDENT
Auto Hang-
Up ON
Handset
Name PHILIPS
Time/Date 00:00; 01-01
Alarm OFF
Alarm Tone MELODY 2
Dial Mode COUNTRY
DEPENDENT
Recall Time COUNTRY
DEPENDENT
PIN 0000
Auto Prefix CLEARED
First Ring ON