Panasonic PV-D4745S - Manual (Page 55)

55
*Important: If a remote control button does not work when pressed,
press the DVD button on the remote and try the button again.
PROGRESSIVE OUT
1
Press to select
“PROGRESSIVE OUT,”
and
press
SET repeatedly
for mode. (See below.)
2
OFF: Progressive scan signal is not output.
ON: Progressive scan signal is output from the
Component Video Output Connector.
Sets the Component Video Output Connector (p. 10, 13)
to output the Progressive scan signal.
3 Press ACTION
to exit this mode.
Press ACTION
to display DVD MAIN MENU.
• If the television is not progressive
compatible, a progressive scan picture
is not available. Connect the Video
Output or S-Video Output connector
(see p. 12, 13) and set
PROGRESSIVE OUT to “OFF”.
• CONSUMERS SHOULD NOTE THAT
NOT ALL HIGH DEFINITION
TELEVISION SETS ARE FULLY
COMPATIBLE WITH THIS PRODUCT
AND MAY CAUSE ARTIFACTS TO BE
DISPLAYED IN THE PICTURE.
IN CASE OF 525 PROGRESSIVE
SCAN PICTURE PROBLEMS, IT IS
RECOMMENDED TO SET
PROGRESSIVE OUT TO “OFF”.
IF THERE ARE QUESTIONS
REGARDING OUR TV SET
COMPATIBILITY WITH THIS MODEL
525p DVD/VCR DECK, PLEASE
CONTACT OUR CUSTOMER
SERVICE CENTER.
Notes
A/V OPTIMIZER
Press A/V OPTIMIZER
in Play mode to display
the A/V OPTIMIZER
selection on-screen.
1
You can set to preset audio/video effects as desired.
SET
ACTION
SELECT
A/V
OPTIMIZER
2 Press A/V OPTIMIZER
to select the desired
mode below.
• Display disappears after
5 seconds.
The video/audio effect of each mode is listed below.
Mode Video Audio
Standard video
Bright areas are subdued.
Brightness and sharpness are
enhanced.
Standard video
Enhances high/low range for
dynamic sound.
Standard audio
Enhances high/low range for
dynamic sound.
Reduces high/low range so dialog
and vocals can be heard clearly. NORMAL
CINEMA
DRAMA
ACTION
• With some discs, the audio/video effect may not be obtained, and the audio/video effects may not
work well.
Note
NORMAL CINEMA
DRAMA ACTION
DVD Operation
PV-D4745S P36-72 (041224).p65 2004/12/24, 13:18 55