Panasonic PV-DF273 - Manual (Page 23)

23 23
TV Operation
DISPLAY
AUDIO
MTS Broadcast/TV Stereo System
Receivable Broadcast Types
The following are possible audio broadcast types and
on-screen displays. The signal being received is indicated with
an “ ” mark while the selected audio mode is indicated with
an arrow. To change the audio mode for these broadcasts, see
the “Audio Mode for TV Viewing” section below.
Press DISPLAY to display the broadcast signal being
received.
MTS Stereo and SAP broadcast
Multi-channel Television Sound Stereo
(main language) and Secondary Audio
Program (sub language) broadcasts are
being received simultaneously. Select
the STEREO or SAP audio mode.
MTS Stereo broadcast
Multi-channel Television Sound Stereo
broadcast. Select STEREO audio
mode.
• If stereo broadcast is weak and the
display fl ickers, select MONO audio mode
for possible improvement.
SAP broadcast
Secondary Audio Program (sub
language). Select SAP audio mode for
the sub language.
Audio Mode for TV Viewing
Press AUDIO to select the desired audio mode as described above.
(Arrow shows selection.)
• Each press of AUDIO will change the audio mode as shown below.
• “SAP” is selected with fi rst press of AUDIO.
MONO broadcast
Normal monaural sound broadcast.
1 2 : 0 0AM CH08
STEREO
SAP
MONO SP
1 2 : 0 0AM CH08
STEREO
SAP
MONO SP
STEREO
SAP
MONO
1 2 : 0 0AM CH08
SP
STEREO
SAP
MONO
1 2 : 0 0AM CH08
SP
< Example >
STEREO
SAP
MONO
Press AUDIO
Press AUDIO
Press AUDIO
Equipped with -TV
Noise Reduction for true MTS
reproduction.
-TV Noise
Reduction is required for good
stereo separation and audio fi delity.
is a registered trademark,
and is licensed by Technology
Licensing.
STEREO
SAP
MONO
STEREO
SAP
MONO