Canadian regulatory information (canada only) – Toshiba e350 User Manual
Page 11
 
Introduction
User's Manual
xi
TOSHIBA Pocket PC e350
Version
1
Last Saved on 04/03/2003 13:38
ENGLISH using Euro_C.dot –– Printed on 04/03/2003 as e350_UK
Canadian Regulatory Information (Canada Only)
This digital apparatus does not exceed the Class B limits for radio noise 
emissions from digital apparatus as set out in the Radio Interference 
Regulation of the Canadian Department of Communications. 
Note that Canadian Department of Communications (DOC) regulations 
provide, that changes or modifications not expressly approved by 
TOSHIBA Corporation could void your authority to operate this 
equipment. 
This Class B digital apparatus meets all requirements of the Canadian 
Interference-Causing Equipment Regulations. 
Cet appareil numérique de la class B respecte toutes les exgences du 
Règlement sur le matériel brouilleur du Canada. 
FCC Class B Digital Devices & Peripheral Devices 
(Declaration of Conformity or Certification 
Authorization) 
Declaration of Conformity Label & Marking Requirements
User Manual must provide user information in accordance with 
±15.19(a)(3), 15.21, 15.27 and 15.105(b): 
Instruction Manual Federal Communication Commission 
Interference Statement 
This equipment has been tested and found to comply with the limits for a 
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits 
are designed to provide reasonable protection against harmful 
interference in a residential installation. This equipment generates, uses 
and can radiate radio frequency energy and, if not installed and used in 
accordance with the instructions, may cause harmful interference to radio 
communications. However, there is no guarantee that interference will not 
occur in a particular installation. If this equipment does cause harmful 
interference to radio or television reception, which can be determined by 
turning the equipment off and on, the user is encouraged to try to correct 
the interference by one of the following measures: 
■
Reorient or relocate the receiving antenna
■
Increase the separation between the equipment and receiver
■
Connect the equipment into an outlet on a circuit different from that to 
which the receiver is connected 
■
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Assure continued compliance (for example, use only 
shielded interface cables when connecting to computer or peripheral 
devices). Any changes or modifications not expressly approved by the 
manufacturer of this device could void the user's authority to operate this 
equipment.