Xena Security XM - Manual (Page 3)

Parts of XENA Alarmed Disc-Lock
The Locking System
• Insert the key in the lock and rotate clockwise. The lock barrel will spring open.
• Slide the unit on to your motorcycle’s front or rear brake disc.
• Locate a hole in the brake disc that will allow the locking pin to pass through.
• Push the lock barrel down to insert the locking pin.
• For double-locking locks, turn the key counter-clockwise to lock; for push-down
locks, simply push until the barrel clicks in place.
3 4
CLAW
Chain Adaptor
CLAW14, CLAW15, CLAW18
CHAIN
10mm/14mm Hardened Steel Chain
XC10-110, XC10-150, XC10-200
XC110, XC150, XC200
CABLE
High-Tensile Steel Cable
XV110, XV150, XV200, XV400, XV800
GROUND ANCHOR
XGA-01, XGA-02, XGA-03
*For more product details, please check with your local XENA dealer or visit
www.xenasecurity.com
1. Thickness of brake-disc: Standard issue on virtually all
motorcycle models at just under 7mm (1/4”)
2. Locking-pin size: from 7mm (1/4”) to 14mm (1/2”) (according
to XENA model).
3. Distance from locking-pin to back of disc-slot*: from 42mm
(1 5/8”) to 65mm (2 1/2”) (according to XENA model).
*Note that the locking pin can pass through ANY hole on
the brake disc (see dark area on diagram).
Fitting XENA to your motorcycle’s brake disc
Area for
locking pin
ENGLISH
1. Silicone gasket
2. Battery pack
3. Lock barrel 4. Locking pin
5. Reflector
6. Screw 7. Alarm module
8. Module cover
(Not apply for XZ1)
A B C